Please be aware of the following matters before operating this equipment to change the mold:

1. The mold size shall not be smaller than the minimum mold size specified in the drawing.

 2. We recommend setting the mold opening force and ejector force of the injection molding machine below 1/3 of the rated suction force of the magnetic template, and the ejector speed below 50mm/s;

3. During the injection molding process, if the mold is damaged and stuck, do not force the mold opening by increasing the mold opening force without limit. Please limit the mold opening force to less than 1/3 of the nominal suction force of the template, and make sure that the mold is connected by driving or safety chain during the forced mold opening process.

4. During the mold changing process, please make sure that the ejector hole of the replaced mold matches the machine, otherwise the mold will fall off during the ejection process.

5. In the process of changing the mold, please make sure whether the ejector stroke of the injection molding machine is set too long. Setting an excessively long ejection stroke will cause the mold to fall off during the ejection process.

6. During the injection molding process, please do not use the nozzle to hit the mold or inject glue without high pressure, otherwise it may cause the mold to fall off.

7. Please carefully clean the suction surface of the mold and the magnetic template before each mold change, and check the flatness of the mold. The presence of an air gap between the mold and the magnetic template will cause magnetic loss.

8. Make sure that the mold temperature is within the temperature range of the magnetic template, over-temperature use will cause permanent damage to the magnetic template.

9. Do not turn off injection molding machine inspection, mold inspection, and interlock control under abnormal conditions.

10. If equipped with safety chain, please be sure to hook the safety chain after the mold change is completed.